Ara
Toplam kayıt 3, listelenen: 1-3
Optimization of tool geometry parameters for turning operations based on the response surface methodology
(2011)
This investigation focuses on the influence of tool geometry on the surface finish obtained in turning of AISI 1040 steel. In order to find out the effect of tool geometry parameters on the surface roughness during ...
Application of Phase Change Materials to Pre-Heating of Evaporator and Pressure Regulator of a Gaseous Sequential Injection System
(2011-07-23)
The vehicle engines having gaseous sequential injection systems of liquefied petroleum gas (LPG) are operated on gasoline until the engine coolant reaches the required temperature because the heat of the engine coolant ...
A new process damping model for chatter vibration
(2011)
This paper presents a new analytical process damping model (PDM) and calculation of Process Damping Ratios (PDR) for chatter vibration for low cutting speeds in turning operations. In this study a two degree of freedom ...