Ara
Toplam kayıt 4, listelenen: 1-4
Decomposition of Process Damping Ratios and Verification of Process Damping Model for Chatter Vibration
(2012)
In the previous study, by the same authors, titled ‘‘A new process damping model (PDM) for chatter vibration (Measurement, 44 (8) (2011) 1342–1348)’’, a new approach has been presented for obtaining process damping ratios ...
A simple approach to analyze process damping in chatter vibration
(2014)
This paper investigates how changes in chatter amplitude and frequency depend on process damping effect in dynamic turning process. For this purpose, the two degrees of freedom (TDOF) cutting system was modeled, and for ...
Optimization of tool geometry parameters for turning operations based on the response surface methodology
(2011)
This investigation focuses on the influence of tool geometry on the surface finish obtained in turning of AISI 1040 steel. In order to find out the effect of tool geometry parameters on the surface roughness during ...
A new process damping model for chatter vibration
(2011)
This paper presents a new analytical process damping model (PDM) and calculation of Process Damping Ratios (PDR) for chatter vibration for low cutting speeds in turning operations. In this study a two degree of freedom ...